Warning: "continue" targeting switch is equivalent to "break". Did you mean to use "continue 2"? in /home/tmag130/public_html/catalog/controller/module/journal2_carousel.php on line 317
Warning: "continue" targeting switch is equivalent to "break". Did you mean to use "continue 2"? in /home/tmag130/public_html/catalog/controller/module/journal2_carousel.php on line 322
Warning: "continue" targeting switch is equivalent to "break". Did you mean to use "continue 2"? in /home/tmag130/public_html/catalog/controller/module/journal2_side_products.php on line 132
Warning: "continue" targeting switch is equivalent to "break". Did you mean to use "continue 2"? in /home/tmag130/public_html/catalog/controller/module/journal2_side_products.php on line 137 Handheld Oscilloscope Hantek DSO1102B - TestMag.ro
CAT I and CAT II: 300VRMS (10×), Installation Category;
CAT III: 150VRMS (1×);
Installation Category II: derate at 20dB/decade above 100kHz to 13V peak AC at 3MHz* and above. For non-sinusoidal waveforms, peak value must be less than 450V. Excursion above 300V should be of less than 100ms duration. RMS signal level including all DC components removed through AC coupling must be limited to 300V. If these values are exceeded, damage to the oscilloscope may occur.
Horizontal
Sample Rate Range
500MS/s--1GS/s
Record Length
1M
Timebase Scale
4ns/div~2000s/div
Vertical
Bandwidth
100 MHz
Vertical Resolution
8-bit resolution, all channel sampled simultaneously
Rise Time
3.5ns
Bandwidth Limit
20 MHz
Low Frequency Response
≤10Hz at BNC
Math
+, -, *, /, FFT
Trigger System
Trigger Types
Edge, Video, Pulse, Slope, Over time, Alternative
Trigger Modes
Auto, Normal
Measurement
Cursor Measurement
Voltage difference between cursors: △V
Time difference between cursors: △T
Reciprocal of △T in Hertz (1/ΔT)
Auto Measuerment
Frequency, Period, Mean, Pk-Pk, Cycli RMS, Minimum, Maximum, Rise time, Fall Time, +Pulse Width, -Pulse Width, Delay1-2Rise, Delay1-2Fall, +Duty, -Duty, Vbase, Vtop, Vmid, Vamp, Overshoot, Preshoot, Preiod Mean, Preiod RMS,