Trigger mode: edge/pulse width/line selectable video/slop/overtime etc.
USB host and device connectivity, standard
Multiple automatic measurements
Four math functions, including FFTs standard
VGA Optional
General Features
Model
DSO5102BM
Number of Channels
2 channels
Bandwidth
100 MHz
Oscilloscope Type
Digital Storage Oscilloscope
Display Type
7 inch TFT, 16 K color
Display Resolution
800 x 480
Sample Rate
Real-Time Sample: 1GS/s
Equivalent Sample: 25GS/s
Inputs
Input Coupling
AC, DC, GND
Inputs Impedance
1MΩ±2% ‖20pF±3pF
Probe Attenuation
1X, 10X
Maximum Input Voltage
CAT I and CAT II: 300VRMS (10×), Installation Category;
CAT III: 150VRMS (1×);
Installation Category II: derate at 20dB/decade above 100kHz to 13V peak AC at 3MHz* and above. For non-sinusoidal waveforms, peak value must be less than 450V. Excursion above 300V should be of less than 100ms duration. RMS signal level including all DC components removed through AC coupling must be limited to 300V. If these values are exceeded, damage to the oscilloscope may occur.
Horizontal
Record Length
2M
Timebase Scale
4ns/div to 40s/div
Vertical
Bandwidth
100 MHz
Vertical Resolution
8-bit resolution, all channel sampled simultaneously
Rise Time
3.5ns
Position Range / Offset Range
2mV/div to 5V/div
Bandwidth Limit
20 MHz
Low Frequency Response
≤10Hz at BNC
Trigger System
Trigger Types
Edge, Video, Pulse, Slope, Over time, Alternative
Trigger Modes
Auto, Normal, Single
Measurement
Cursor Measurement
Voltage difference between cursors: △V
Time difference between cursors: △T
Reciprocal of △T in Hertz (1/ΔT)